Summary; Assembling Instructions; Install Lower Bar; Install Curved Handle - Grizzly ARM 4051 A Lion-Set Translation Of The Original Instructions For Use

Summary

1 Curved handle
2 Tightening lever
3 Cable holder
4 Lower bar
5 Lower wing nut
6 Battery cover
7 Rechargeable battery
7a Battery Indicator
7b Locking button
8 Front wheels
9 Lateral impact protection
10 Housing
11 Battery charger
11a Display Battery charger
12 Back wheels
13 Cutting height adjuster
14 Rear impact protection
15 Collection bag
15a Fill-level indicator
for grass collection bag
16 Connection cable l
17 On/Off button
18 Drive bracket
19 Safety switch
20 Battery Indicator
21 Lateral ejection chute
22 Mulching kit
23 Safety key
24 Blade
25 Locknut

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confident.
• In case of uncertainty, contact a speci-
alist or contact our service directly

Install lower bar

1. Press the ends of the lower
handle (4) somewhat together
and set them into the guide rails
on the right and left of the device
housing (10).
2. Run the screws from the outside
through the hole on the device
housing (10). Attach the washers
and the lower wing nuts (5) onto
the screws from the inside and
use them to fix the lower part of
the handle to the device.

Install curved handle

1. Push the ends of the curved
handle (1) slightly apart and in-
sert these into the slots provided
on the lower part of the handle
(4).
2. The tilt of the curved handle
(1) is continuously adjustable
through appropriate positioning.
Bring the curved handle (1) into
the desired position and fix it with
the supplied nuts, washers and
the upper quick-release levers
(2) to the left and right sides of
the lower part of the handle (4).
3. Clipping in the cable holders:
Clip the cable holders
(3 ) onto the lower bar to fixa-
te the machine cable (16
If you loosen the quick release
levers and wing nuts, you can fold
down the curved handle and the
lower part of the handle for storage
of the device.
GB
).
33