Matan Barak Series Technical Note page 6

8. Gently pull the right end of the S
beam, as shown below.
Peel off the
protective tape
from the Scale
Stick the end of the magnetic scale to the right side of the beam
9. Peel off the protective tape from the adhesive strip of the S
above.
10. Place the J
Protective Strip
Encoder Scale
11. Place the M
12. Using the jig to keep it in the right position, stick the M
the entire B
adhesive strip, as shown below.
10100139 - C
on the S as shown below.
IG CALE
S J , on the M
AGNETIC CALE IG
, and at the same time, remove the protective tape of the
EAM
© Matan Digital Printers Ltd.
to the very end of the right end of the
CALE
End of the beam
Jig
S
AGNETIC CALE
, as shown
CALE
as shown above.
S along
AGNETIC CALE
Page 6 of 13