System Setup - UVP MultiDoc-It Installation And User Instructions Manual

MultiDoc-It Imaging System

System Setup

DO NOT ATTEMPT TO CONNECT ANY WIRING WHILE THE EQUIPMENT IS CONNECTED TO A
POWER SUPPLY.
CAUTION: Do not install the system in places with high moisture, dust or high temperature. Do not use
any oil or petroleum based cleaner for the cabinet. Use only mild soap or detergent solution for
cleaning. Ensure that the system is turned OFF during cleaning. Keep the equipment away from motors
or other large magnetic equipment apparatus.
Power Connections
1. On the rear of the transilluminator,
attach one end of the jumper cord into
the transilluminator and other end of
the jumper cord to back of the
darkroom.
2. Attach the main power cord to the top-
rear of the darkroom and the other
end of the main power cord into a
power outlet (a surge suppressor is
recommended).
Filter Installation
1. Unscrew the four plastic head screws
(Fig. 1) that hold the filter tray to the
camera mounting plate.
2. Remove the filter tray from its position
and place the filter(s) in the square
recessed areas (Fig. 2).
3. Reattach the filter tray to the camera
mounting plate with the four plastic
head screws (Fig. 1).
Connecting the Optional UV Lamps
1. Insert a lamp into each bracket (Fig. 3)
so that the cord is directed to the back
of the darkroom.
2. Run the cord behind the camera
mounting plate (shown in Fig. 1) and
plug into the lamp outlet.
Head Screw
Camera
Mounting
Plate
Filter Tray
Lamp Outlets
Lamp Bracket
Figure 3
4
Figure 1
Filter Selector
Knob
Figure 2
81-0214-01 Rev L