Table of Contents
Advertisement
QUICK START GUIDE
Interior Adjustments (RE Models)
Slide-out Metal Shelf Removal
All models feature side mounted rack supports with 19
adjustment positions.
All refrigerators ship with 2 slide-out metal shelves.
Remove and reposition as desired.
Note: Do not exceed 52.8 lb (24 kg) per shelf when
loading.
1.
Remove all items from shelf.
2.
Pull shelf out far enough to firmly grasp both sides.
Lift front end slightly (about 1⁄4") to center the pin in
the slot.
3.
Pull shelf towards you until all pins are clear of the
slots. If only repositioning the shelf, do not remove
completely - go to "Stainless Steel Shelf Installation"
Step 2.
4.
Slightly tilt one side. Gently pull shelf towards you to
remove from unit.
Note: Take care when removing shelf to avoid
scratching interior of unit.
5.
Once removed, retract the slides.
Note: The slides on the shelf have a thin coating which
is used to block moisture and provide lubrication. Use
care when handling.
Slide-out Metal Shelf Installation
1.
Fully extend slides on both sides of shelf.
2.
Insert shelf into unit with one side tilted slightly
upward until back pin is between front and rear rail
supports.
3.
Tilt shelf back to horizontal and line up 2 back pins
with rear rail support. Line up left side of shelf with
Center
the pin
rear and front rail support. Continue inserting shelf
until both pins engage. The front will set down slightly
and lock into place. Repeat on right side.
10
Center
the pins
Front Pin
Back Pin
u-line.com
Advertisement
Table of Contents
