Advertisement
operating
Instructions
for
Your P ortable
washer —
Model WWPI170B
This washer may be used in two
ways — as a portable or as a built-
in washer. Chances are you will
first use it as portable and then
have it permanently installed at a
later date.
When using your washer as
portable, roll it to the most level
position near the water and power
source. Once the washer is in
position press "Lock Lever" with
your foot (See illustration A) to
secure washer in position. Make
sure washer is firm to the floor and
does not rock. Washer will not
move until [ever is released. When
you have finished washing, press
'[Release Lever" (See Illustration B)
and roll washer to your storage area.
iLLLISTRATION A–LOCK ILEVER
Press "Lock Lever"- Iever on right
to secure your washer in position.
How
to
Load Ycw
washer
* Load clothes loosely. Dry clothes
level should be below bottom of
wash tub rim. Do not put clothes
on top of the agitator or wind them
around it. For best results, mix
large items with small ones. When
washing a single heavy item, such
as a shag rug or bedspread, add
one or two other pieces to balance
the load. Large items should be no
more than one-half of the total load.
~ Clean lint filter. Be sure filter is
cleaned before washing every
load. See page 19.
~ Add measured amount of
detergent according to load size,
amount of soil and water level. See
pages 7 through 9 for detailed
information on types and amounts
of detergent.
~ See page 11 for instructions on
how to use bleach, fabric softener
and other laundry products.
@ Close lid. Washer will fill and
agitate but will not spin with lid
open. This washer has a Safety Lid
Lock. As a safety measure the lid
will be automatically locked during
the spin portion of each cycle. The
lid will automatically unlock about
30 seconds after the end of the
spin cycle. To open lid during spin
cycle, push Cycle Selector IN and
wait for lid lock to release, about
30 seconds, before opening.
For your personal safety, never
reach into washer while parts are
moving. Always stop washer to
load, unload, add forgotten items
or additional laundry aids.
ILLUSTRATION B—
RELEASE' Ml/m
Press ';Release Lever''—lever on
left before you attempt to move
washer.
4
set
the Cxmtrds
See the Controls Setting Guide on
page 5.
Select Water Level
SMALL: Washer is less than 1Afull
of clothes.
VARIABLE: Set between SMALL
and LARGE to adjust load sizes
between % and 2A full.
LARGE: Over 2/sfull.
If you wish to increase level after
you've made a selection, turn knob
to "RESET" and select new level.
Select Wash/Rinse Temperature
Set Wash/Rinse Temperature
switch at Warm/Warm (MANUAL)
and leaveit at this setting
To
connect washer you must first
install a faucet adapter according
to the instructions included with
the faucet adapter package. Grasp
couple~ pull hoses out of cabinet
until red marker on hoses is
visible.
Attach the washer's hose coupler
to the faucet, (See Illustration C).
ILLUSTRATION C
Grasp white ring on hose coupler
and pull it down. Slip hose coupler
over faucet adapter and release
white ring. This will connect hose
coupler to faucet adapter. To test
the water temperature, press the
Advertisement
