Installing A Fan Module; Verifying The Fan Module - Cisco MDS 9396S Installing

Hide thumbs Also See for MDS 9396S:

Table of Contents

Installing a Fan Module

Step 5

Once the fan blades have stopped spinning, remove the fan module completely from the fan bay.

Installing a Fan Module

To install a new fan module, follow these steps:

Step 1

Slide the fan module into the fan module bay until it clicks into place.

Step 2

Tighten the fan module captive screw.

To verify that the new fan module is installed correctly, follow these steps:

Step 1

Listen for the fans; you should immediately hear them operating. If you do not hear them, ensure that the fan module is

inserted completely in the switch and the faceplate is flush with the switch back panel.

Step 2

Verify that the fan module LED is green. If the LED is orange, then one fan has failed in this fan module; if the LED is

red, then both fans have failed in this fan module.

Step 3

Contact your customer service representative for assistance if, after several attempts, the fans do not operate or you

experience trouble with the installation.

Note

If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If you

purchased this product directly from Cisco, contact Cisco Technical Support at this URL:

http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html

Installing the Cisco MDS 9396S Switch

Table of Contents