Husqvarna PP 492 Operator's Manual page 13

WARNING: A higher speed than the
recommended speed can result in injury and
damage to the product.
The wall saw has 2 mechanical gears. For more
information on recommended blades and speeds, refer
to the operator's manual of the wall saw.
1. Select "DRIVE CHOICES" menu and then select
"SET GEAR".
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
2. Select the correct gear. Refer to
overview on page 8 .
3. Select "DRIVE CHOICES" menu and enter the "SET
DRIVE MODE".
4. Select the applicable "DRIVE MODE". The product
can be used for wall sawing, chain sawing or wire
cutting.
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
5. Select "CALIBRATE ARM" menu. The pivot arm will
be calibrated. Refer to
page 8
6. Select "SET BLADE DIAMETER" menu and enter
the correct blade diameter.
Note: The depth indication on the display will only be
correct if you calibrate the arm and enter correct blade
diameter. This will also make the chain saw adapter
operate correctly.
Note: You can select the "SET DRIVE MODE" menu
from the main menu with the arrow buttons.
To operate the product with the remote control
These operation procedures are applicable for wall saws
with blade, wire or chain. Use the dials on the remote
control to do the operations that follows:
967 - 001 - 04.02.2020
20 DEC 20:55
Menu system
20 DEC 20:55
Menu system overview on
• Longitudinal movement: The dial moves the wall saw
along the rail.
• Arm movement: The dial moves the pivot arm to
adjust the cutting depth.
• To rotate the cutting equipment and to control the
speed of the cutting equipment. The "RETURN"
button (A) starts the cutting equipment, the dial (B)
adjusts the speed in which the cutting equipment
rotates.
Push and hold the "RETURN" button (A) while you
turn the dial (B) clockwise to increase the speed in
which the cutting equipment rotates.
A
OK
ON/OFF
0
OK
ON/OFF
0
OK
ON/OFF
0
B
13