Advertisement
2. Remove the oil drain plug.
3. Connect a hose to the oil drain hole.
4. Tilt the product and let the oil run through the hose
and into the container.
5. Install the oil drain plug and tighten it.
6. Fill with new engine oil. Refer to
page 13 for the correct type of oil.
7. Do a check of the engine oil level.
To replace the oil in the rammer leg
1. Put a container below the oil drain plug.
2. Remove the oil drain plug.
3. Let the oil run out into the container.
4. Install the oil drain plug and tighten it. Make sure that
the sealing washer is not damaged.
5. Remove the sight glass.
1167 - 003 - 09.03.2020
Technical data on
6. Fill with new oil through the hole for the sight glass.
Technical data on page 13 for the correct
Refer to
type of oil.
7. Install the sight glass and tighten it fully.
8. Do a check of the oil level.
To do a check of the oil level in the
rammer leg
1. Put the product in upright position.
2. Look at the sight glass (A). The oil level is correct
when it is at the middle of the sight glass.
A
To clean or replace the air filter
WARNING: Use approved respiratory
protection when you clean or replace the air
filter. Discard used air filters correctly. The
dust in the air filter is dangerous to your
health.
WARNING: Do not clean the air filter with
compressed air. This causes damage to the
air filter and the risk increases that you
breathe the dangerous dust.
1. Turn the knob on the air filter cover and remove the
air filter cover.
2. Remove the air filter.
11
Hide quick links:
Advertisement
