Bosch DDW88MM65 User Manual And Installation Instructions page 18

en Installation instructions
Pull the cable connection into the strain relief
2.
remove the transport lock ⁠ .
Note: To ensure that the appliance is not yet fully in-
3.
serted into the cut-out, place a slat below the short
side of the appliance in each case.
Insert the appliance into the cut-out in the worktop
from above.
Insert the appliance evenly so that it is not tilted.
Mark the cut-out for the pipework:
4.
Attach the exhaust air hose for the fan box to the
‒
connector.
Slide the fan box into the guide and tighten this
‒
with a screw.
Mark the position of the pipework on the bottom
‒
of the unit.
Undo the screw and remove the fan box again.
‒
Saw out the cut-out for the pipework.
5.
18
and Slide the fan box into the guide, connect the pipe-
6.
work and screw the fan box tightly back in place.
Support the appliance from below and remove the
7.
slats.
Insert the appliance fully in the cut-out.
8.
Align the rails to the bottom
9.
side .
Screw the rails onto the bottom of the unit.
10.
Screw in the screw from below and tighten the nut.
11.
and attach to the