Bosch DDW88MM65 User Manual And Installation Instructions page 17

¡ The width of the extractor hood must correspond at
least with the width of the hob.
¡ To optimally detect the cooking vapours, install the
appliance behind the hob.
¡ In order to freely access the fan box for servicing,
select an easy-to-reach installation site.
¡ The surfaces of the appliance are sensitive. Avoid
damaging them during installation.
15.8 Installation
Checking the units
Check whether the fitted unit is level and has suffi-
▶
cient load-bearing capacity.
The max. weight of the appliance is 40 kg.
Preparing the units
Note: To install the hob and the appliance seamlessly,
you require special accessories, which are not included
in the scope of delivery. Observe the enclosed installa-
tion instructions for special accessories.
Requirement: The unit is suitable for the installation.
Make a cut-out in the worktop, depending on the in-
1.
stallation position.
The angle between the cut surface and the worktop
must be 90°.
Ensure that the worktop has sufficient load-bearing
2.
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
Ensure that the fitted unit is still stable after the cut-
3.
outs have been made.
Remove any shavings.
4.
Depending on the installation position, remove the
5.
back panel of the fitted unit.
Preparing the appliance
WARNING ‒ Risk of injury!
The appliance is heavy.
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
▶
Place the appliance on a soft surface and remove
1.
the transport lock.
Stick the sealing in the designated groove
2.
trim it ⁠ .
Screw the covering plate in tightly, depending on
3.
the installation position.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
The appliance is heavy.
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
▶
Note: To protect the cables, do not remove the trans-
port lock yet.
Lift the appliance by the short sides and align the
1.
front of the appliance with the hob.
Installation instructions en
and
17