Table of Contents
Advertisement
Step 3 | Change the latch bolt direction
You can change the direction of the latch bolt to adapt to doors of different
opening directions. When the bolt bevel faces out the door, it is for outwards
door opening; And when the bolt bevel faces in the door, it is for inwards
door opening.
Inverting tailpiece
Latch bolt
Directional
screw
Attention
1. Choose a proper installation kit based on the door thickness;
2. The default tool kit is applicable to door thickness of 38-60mm. If your door thickness is out of
this range, please contact us.
Installation steps
The following installation steps apply to right-open doors. For left-open doors,
please read the [Pre-installation instructions] carefully and make needed
adjustments.
Use the drilling template to drill
1
the needed holes on the door and
mount the mortise into the door.
6
1. Push the inverting tailpiece to the top.
2. Press the latch bolt down to the mortise
surface, then rotate it 180 degrees and pull it
out.
3. Push the tailpiece to the bottom.
4. Change the direction of the directional screw
according to your actual needs (the directional
screw must be installed on the inside of the
door, i.e. the inside escutcheon)
Tighten up the 4 fixed screws
2
when inserting the mortise.
Install the connecting screw tube
3
, and place the square shaft and
compressed spring into the hole
of the lever. (The square shaft
compressed spring must be put
towards the lever)
Attention
Please cut the key tailpiece according to your needs
and
use square shaft and connecting screw tube
with proper length to fix the screw tube.
Tighten up the mounting plate
5
with 3 anchor screws against the
inside of the door.
Pass the connection wire through
4
the hole on the mortise. Align the
cylinder key tailpiece and the
square shaft with the 2 rotary
holes on the mortise, and insert
them to make sure the outside
escutcheon is kept close to the
outside of the door.
Put
the
compressed
spring,
6
then the square shaft into the
inside
escutcheon.
Insert
the
outside escutcheon connection
wire and mortise wire into the
corresponding sockets on the
inside
escutcheon.
Align
the
square shaft to the rotary holes
on the mortise and insert them to
make the inside escutcheon close
to the inside of the door.
Attention
Please
make
sure
the
extra
connection wire is hidden in the
door hole.
7
Hide quick links:
Advertisement
Table of Contents
