Advertisement
Disconnect power source
†
230V
0FF
Pierce the required rubber seals for the cables
†
Make marks for the holes and drill the holes
†
Feed the cable through the seal of the base
†
Tighten the screws
†
Connect the individual wires to the appropriate terminal
†
and tighten the screws
Plug the LED lamp on the base and connect to the mains
†
L The device needs approx. 40 s of preheating time.
Ø 6mm
5. Description
Refl ector
Motion detectors
6. Setting
Using the grouping function (setting the wireless
channel)
L The LED lamps can be set and operated in a wireless
network. Any number of devices with and without motion
detector can be operated on one wireless channel.
L The grouping function can also be activated via theSenda
Plug app (parameter→ RF channel)
In order to switch on several devices in case of motion,
set the potentiometer to the same wireless channel 1–6 at
†
all LED lamps
L If the set value is changed at a potentiometer, the values
will be accepted by both potentiometers (for bright-
ness and time) – regardless of the settings via app or
theSenda P.
L For settings that can be made with the app or on the
device, the last set value is always saved.
Potentiometer to set the
wireless channel for grou-
ping devices (on the rear of
the device)
2 potentiometers to set time
delay and switch-on bright-
ness (on the bottom side of
the device)
2
Advertisement
