Advertisement
Land Pride
Section 8: Troubleshooting
Section 8: Troubleshooting
Symptoms
Starting motor does not crank
Engine cranks but does not start
Engine:
Runs with continuous misfiring or
engine runs unevenly or erratically
Grass cutting is ragged or uneven
Loss of power or system will not operate
in either direction
2/10/09
Table of Contents
Probable Causes
Control levers are not in neutral
position
Park brake not engaged (ON)
Blade Engagement switch is engaged
Weak or dead battery
Loose or broken switches
and/or damaged electrical wiring.
For additional causes
No fuel in the fuel tanks
Fuel filter and/or fuel line plugged
Fuel tank valve turned to "OFF"
Fuel tank valve turned to an empty
tank
Numerous
Numerous
Dull, bent or broken cutting blades
Deck full of wet sticky grass
Cutting Blades are not operating at full
engine speed
Belt over center take-up is loose
Worn or broken belt
Deck is not level
Bypass valve open
Linkage bolt is loose or lost
Bad ground drive belt and/or pump
idler pulley
Loose, lost or broke idler pulley spring
Restrictions in air cleaner
Internal interference or leakage in
Hydro-Drive
Insufficient hydraulic oil supply
Poor compression
Steering linkage needs adjustment
Air in system
For additional causes
ZXT54 & ZXT60 Pro Series Zero Turning Radius Mowers Riding Mowers 357-271M
Suggested Remedies
Place control handles in neutral (OUT)
Engage park brake
Disengage blade switch
Recharge or replace
Repair or replace switches and
electrical wiring
See engine manual
Fill tank
Replace fuel filter and/or fuel line
Select a fuel tank with gasoline
See Figure 5-12 on page 39.
Switch fuel valve to the other tank
See Figure 5-12 on page 39.
See engine manual
See engine manual
Sharpen or replace cutting blades
Clean underside of deck
Increase engine rpms to full speed
(3600 rpm)
Tension over center take-up
Replace worn and broken belt
See "Belt Maintenance" on page 42
Check air pressure in all 4 tires
Make level adjustments to the deck
See "Deck Leveling Adjustments" on
page 26
Close bypass valve
See Figure 2-8 on page 18
Replace linkage bolt
Replace belt and/or idler pulley
Tighten idler pulley if loose
Reattach or replace idler pulley spring
Service air cleaner
See your dealer
Check hydraulic oil level in expansion
tank and add oil if needed
See your dealer
Adjust linkage See "Steering
Adjustments" on page 22
Check filter & fittings
See engine manual
53
Advertisement
