Advertisement
Land Pride
Section 5: Maintenance & Lubrication
Service at Intervals Indicated
Clean mower, Deck & Engine Cooling System
Verify Safety Start Interlock System
Inspect Unit for loose hardware and damage
Visually Inspect Tires
Check Engine Oil Level
Clean Air Intake Screen
Check Fuel Level
Blades - Sharp & Securely Fastened
Discharge Chute -
Securely In Place & In Lowest Position
Grease Blade Spindle Bearings
Change Engine Oil & Filter (1)
Clean Cylinder And Head Fins
Check Battery Connections
Check Tire Pressure With A Gauge
Clean Engine Exterior (3)
Check hydraulic Oil Level
Tighten Lug Nuts On Wheels (2)
Grease Caster Wheel Bearings
Check Ground And Deck Belt Tension (4)
Check Fuel and Hydraulic Lines (5)
Change Fuel Filter (3)
Grease Deck Lift Points (8)
Grease Deck Lift Pivot Points (8)
Replace Spark Plugs(3)
Replace Air Cleaner Paper Element (6)
Grease Front Axle Center Pivot (8)
Grease Idler Arm Pivot Pin (8)
Change Hydraulic oil & Filter (7) (8)
NOTES:
1. Initial engine oil and oil filter change is after the first 5 hours of operation. Thereafter, change engine oil and oil filter
every 50 hours of operation. Change every 25 hours when operating the engine under dusty or dirty conditions,
heavy load, high temperatures and hot weather periods. Refer to Engine Owner's Manual.
2. Torque lug nuts initially and after first 2 hours of operation.
3. Remove cooling shrouds and clean cooling areas. Check oil cooler fins and clean as needed. Refer to Engine
Owner's Manual.
4. Inspect ground and deck belt tensions every 6 months or 100 hours and replace if worn or cracking is noticed.
Otherwise, replace every 200 hours or 2 years whichever comes first.
5. Check fuel line hoses and fuel valve for any cracks or leaks.
6. Replace air cleaner filter element if damaged, every 200 hours or every season (whichever comes first). Replace
more frequently when used in dusty conditions.
7. Initial hydraulic oil and filter change is between 25 and 50 hours of operation.
8. X/M = Service per hours indicated in column or monthly (whichever comes first).
X/A = Service per hours indicated in column or annually (whichever comes first).
2/10/09
Table of Contents
Maintenance Schedule
Every
Every
25 Hrs
50 Hrs
Daily (After engine has cooled.)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use or every 4 hours, whichever comes first)
Daily (Before each use or every 4 hours, whichever comes first)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use)
X
X
X
X
X
X
X
X
ZXT54 & ZXT60 Pro Series Zero Turning Radius Mowers Riding Mowers 357-271M
Every
Every
100 Hrs
200 Hrs
500 Hrs
X
X
X
X
X/M
X/M
X
X
Every
Refer to
Page
16
32
55
39
40
38
32 & 44
47
39
11 & 36
55
37
32
47
42 & 42
38
38
48
40
X/A
48
X/A
48
X/A
37
33
Advertisement
