Installing A Windows Driver - PrimaLuna EvoLution Series Manual

Installing a Windows Driver

If you plan to use the EVO 100-9 DAC with a Windows-based computer, you need to install a USB
Audio Driver in your computer before you can use the DAC as an outboard USB sound card for your
audio system.
The steps for installing the Windows driver are as follows:
1. Connect the DAC to the computer with a USB cable.
2. Turn on the DAC by pressing the Power ON/OFF button on the left side.
Select the USB AUDIO input by pressing the USB button on the front panel, or press the
USB button on the remote control.
3. Get your USB audio driver from your dealer, distributor or direct from Durob Audio BV:
service@durob.nl.
4. Activate the driver installation process, skip all warnings until the installation process is
completed.
5. If the driver has installed successfully, you should be able to see the name "XMOS USB
AUDIO" at the Device Manager interface of your computer,or sometimes the device name will
be displayed as "PrimaLuna EVO 100 Tube Digital Analogue Converter".
Select "XMOS USB AUDIO" or "PrimaLuna EVO 100 Tube Digital Analogue Converter" as an
6.
audio output device in your computer playback software.
EvoLution Series
8