1St Op Roll Height And Gap Adjustment - KegLand Cannular Instruction Manual

Cannular Semi-Auto Instruction Manual
Note: The rollers have been removed from the machine in the above diagram for
explanatory purposes only.
Generally once this has been set and tightened it will not need to be adjusted.
st
1 Op Roll Height and Gap Adjustment
The right roller undertakes the 1
automatic Cannular.
To ensure you get the can within the specification it's vital that
st nd
the 1 and 2 Op rolls are correctly adjusted. In order to carry
out these adjustments on the machine it's recommended that
you use a feeler gauge set (KL13420)
Always adjust the gap "Y" first, as gap "X" will change
any time you change gap "Y".
st
Set the 1 Op Roller height (y-axis)
1. Unplug the power from the machine
2. Turn the chuck clockwise until the 1
its closest position to the chuck. NEVER turn the
chuck anti-clockwise as you can damage the
motor if you do.
3. Using a 14mm spanner or socket, loosen the y-
axis adjustment nut.
4. Slide the roller vertically along the drive shaft to set the gap "y" at 0.05 - 0.15 mm
5. Tighten the y-axis adjustment nut firmly once at the correct gap "Y" size to fix the
roll in position
st
Set the 1 Op Roller Gap (x-axis)
1. With the roller at its closest position to the chuck using a 14 mm spanner or socket,
loosen the x-axis adjustment nut.
Page 12 of 23
st
Operation on the Semi-
st
roller is at
www.KegLand.com.au Last Updated 24/04/2020 5:59 PM