Table of Contents
Advertisement
ELECTRONIC OVEN CONTROL
7
1. Oven Display
2. Lower Oven Start and Cancel
Pads
3. Number Pads
Display(s)
When power is first supplied to the appliance, everything on the
display(s) will light up for 5 seconds. Then, "PF id = 27" or
"PF id = 30" will appear. Press LOWER OVEN CANCEL, UPPER
OVEN CANCEL or CANCEL OFF (on some models) to clear
display(s).
Any other time "PF id = 27" or "PF id = 30" appears, a power
failure occurred. Depending on your model, press LOWER OVEN
CANCEL, UPPER OVEN CANCEL, CANCEL or CANCEL OFF and
reset the clock if needed.
Lower Oven Display (combination oven models)
When the lower oven is in use, this display shows the lower oven
temperature, heat source(s) and start time.
During lower oven Timed Cooking, this display also shows a
vertical bar and minute time countdown and the stop time (if
entered).
If "Err" appears on the display, an invalid pad was pressed.
Depending on your model, press LOWER OVEN CANCEL,
UPPER OVEN CANCEL, CANCEL or CANCEL OFF and retry your
entry.
When the lower oven is not in use, this display is blank.
Upper Oven Display (combination oven models),
Display (single oven models)
When the upper oven or single oven is in use, this display shows
the upper oven or single oven heat source(s), cooking power,
quantities, weights and/or help prompts.
If "RETRY" flashes on the display for one second, an invalid pad
was pressed. Retry your entry.
When the upper oven or single oven is not in use, this display
shows the time of day or Timer countdown.
8
2
8
4. Time of Day/Timer Display
5. Timer Pads
6. Clock Set/Start Pad
7. Oven Setting Pads
This is a 12 hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the ovens, Timer and Timed Cooking
are off.
1. Press CLOCK SET/START.
2. Press the number pads to set the time of day.
3. Press CLOCK SET/START, START or EASY MINUTE START.
To remove the time of day from the display: Press and hold
CLOCK SET/START for 5 seconds.
To return the time of day to the display: Press CLOCK SET/
START. The time should not have to be reset.
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End-of-cycle
Reminder, repeating each minute after the end-of-cycle tones
All Tones (combination oven models only)
All of the above tones are preset on, but can be turned off.
To Turn Off/On: Press and hold STOP TIME for 5 seconds. A
tone will sound and "Snd oFF" will appear on the lower oven
display for 3 seconds. Repeat to change back to "Snd on."
3
4
9
8. Timed and Delayed Cooking
Pads
9. Oven Light Pad
10. Upper Microwave Oven
Control Panel
Clock
Tones
5
6
10
Advertisement
Table of Contents
