Panasonic CF-31 Series Operating Instructions Manual page 17

12 At the confirmation message, click [YES].
Installation starts according to the instructions on the screen. (It will take approximately 20 minutes.)
l Do not interrupt installation, for example by turning off the computer or performing other operation.
Otherwise installation may become unavailable as Windows may not start up or the data may be corrupted.
13 When Ending process screen is displayed, click [OK] to turn off the computer.
14 Turn on the computer.
l If the password is requested, enter the Supervisor Password.
15 Perform the "First-time Operation" (è page 9).
NOTE
The date and time, and the time zone may not be correct. Be sure to set them correctly.
l
16 Start the Setup Utility and change the settings as necessary.
17 Perform Windows Update.
18 <Only for model with TPM> Clear TPM (è page 15).
n Using Recovery Disc
Use the Recovery Disc in the following conditions.
Ÿ You have forgotten the administrator password.
Ÿ Installation is not complete. The recovery partition in the hard disk may be broken.
<Only for Windows 7 downgrade model>
Ÿ
To change OS from Windows 7 to Windows 8.1, or vice versa.
NOTE
To change OS from 32 bit to 64 bit, or vice versa, install OS using the recovery partition in the hard disk.
Ÿ
Preparation
l Prepare the following items:
Ÿ Recovery Disc (è
Ÿ DVD drive (optional) (refer to recent catalogs and other sources for information about the products avail-
able)
l Remove all peripherals.
l Connect the AC adaptor and do not remove it until installation is complete.
1 Connect the DVD drive to the USB port or Multimedia Pocket.
2 Start the Setup Utility.
A Display "Charm", and click
B Click [Restart now] under "Advanced startup".
C Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
Turn on the computer, and press F2 or Del while [Panasonic] boot screen is displayed.
l If the [Panasonic] boot screen is not displayed, turn on the computer while holding down F2 or Del .
l If the password is requested, enter the Supervisor Password.
3 Write down all of the contents of the Setup Utility and press
At the confirmation message, select [Yes] and press Enter .
4 Check the [UEFI Boot] setting of the Setup Utility.
[UEFI Boot] should be set to as follows.
When the recovery disc for Windows 8.1 is used : [Enabled]
When the recovery disc for Windows 7 is used : [Disabled]
5 Set the Recovery Disc into the DVD drive.
6 Press .
F10
At the confirmation message, select [Yes] and press Enter .
Computer will restart.
7 Press or
F2 Del
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
Reference Manual "Recovery Disc Creation Utility")
- [Change PC settings] - [Update and recovery] - [Recovery].
while [Panasonic] boot screen is displayed.
.
F9
17