Starting Up/Shutting Down - Panasonic CF-W2 Series Operating Instructions Manual

Starting Up/Shutting Down

Starting Up
16
1
Open the display.
Slide the latch (A) located at the front.
1
Lift open the display.
2
CAUTION
Do not open the display wider than necessary (135° or more).
Do not apply excessive pressure to the LCD. Also, do not hold the LCD when
opening or closing the display.
2
Turn your computer on.
Slide the power switch (B) and hold it for approximately one second until the power
indicator (C) turns on before releasing it.
CAUTION
While booting, avoid the following until the hard disk drive indicator (
turned off.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch.
• Performing any keyboard, touch pad, or external mouse operations.
• Closing the display.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
When the CPU temperature rises, the computer may not power on to prevent the
CPU from overheating. Should this happen, allow the computer to cool down
then switch the power on again.
If the computer still does not power on, contact your technical support office.
( page 41)
If [Enter Password] is displayed
Enter your password*
Enter Password [
1 Supervisor Password or User Password set in the Setup Utility (not
*
the Windows password).
When an application or file that was previously displayed
appears on your screen
The standby or hibernation mode has been set (
Functions").
and press Enter . (
1
The correct password
]
Three incorrect attempts
or
No password for about a minute
) has
"Security Measures")
Will Start
Will Not Start
(Power off)
"Standby/Hibernation