Starting Up/Shutting Down - Panasonic CF-47 Series Operating Instructions Manual

Starting Up/Shutting Down

Starting Up
2
1
Power Indicator
Power Switch
Sleep Switch
1
Open the display
Slide the latch as shown and lift open the display.
2
Turn your computer on
The following two methods are available.
Slide the power switch toward the rear of the computer and hold it for approxi-
mately one second until the power indicator turns on before releasing it.
Press the sleep switch* and hold it until the power indicator turns on before releas-
ing it.
*
Power cannot be turned on with the sleep switch when the power goes off by holding down the sleep
switch for more than four seconds, or when both the AC adapter and battery pack are reconnected after
having been disconnected.
CAUTION
The computer will not power on when the display is closed.
After confirming that the power indicator has turned on, avoid the following
until Windows has completed loading.
• Connecting or disconnecting the AC adapter.
• Touching the power switch or the sleep switch.
• Performing any keyboard or touch pad (or external mouse) operations.
• Closing the display.
If the display is closed while Windows is starting up, it is possible that color, etc.,
will not be displayed properly. Run the [MS-DOS Prompt] ([Start] - [Programs]
- [MS-DOS Prompt]), and use full screen display mode by pressing
Enter . After returning from the full screen mode (
the display will be shown correctly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
When the CPU temperature rises, the computer may not power on to prevent
the CPU from overheating. Should this happen, allow the computer to cool
down then switch the power on again.
If the computer still does not power on, contact Panasonic Technical Support.
If the computer has not been used for a long period of time, it may produce an unusual
sound at start up. The sound may continue for a short period of time, but if the computer
starts up in a normal manner, then the problem is not serious. If, however, the computer
fails to start up, contact Panasonic Technical Support.
If security indicator (
you must first enter your User Password (
Upon entering your User
Password and pressing
Enter
*
If after three attempts the correct password is not input, or if no pass-
word is entered for about a minute, the computer returns to the condi-
tion just before the attempt was made to start up the computer.
When an application or file that was previously displayed ap-
pears on your screen,
the suspend or hibernation mode (
) is displayed,
"Security Measures"
If the correct password is input,
Over three incorrect attempts,
"Suspend / Hibernation Functions") has been set.
Alt +
again),
Alt + Enter
)
Will Start
Will Not Start*
(Power off)
15