Table of Contents
Advertisement
Starting Up/Shutting Down
Starting Up
Latch B
2
Latch A
Power Switch
Power Indicator
1
Open the display.
Pull up latch A and release latch B.
1
Lift open the display.
2
1
2
Turn your computer on.
Slide the power switch and hold it for approximately one second until the power
indicator turns on before releasing it.
CAUTION
While booting, avoid the following until the hard disk drive indicator
turned off.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch or the tablet buttons.
• Performing any keyboard, touch pad, touchscreen (or external mouse) op-
erations.
• Closing the display.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
When using this computer with the battery pack only, it may take some time
for the power to turn on after sliding the power switch. In this case, slide the
power switch and hold it for more than one second. This phenomenon occurs
because the standby power is minimized while the power is turned off; it is
not a malfunction.
When the CPU temperature rises, the computer may not power on to prevent
the CPU from overheating. Should this happen, allow the computer to cool
down then switch the power on again.
If the computer still does not power on, contact Panasonic Technical Support.
NOTE
When the power is turned on in a low-temperature environment, sometimes
the message "Warming up the system. Please wait..." is displayed (up to 25
minutes) or the battery indicator alternately blinks green and orange. This
function is designed to prevent hard disk drive malfunctions that may occur at
low temperatures. Wait for the computer to start up.
has
17
Advertisement
Table of Contents
