Panasonic CF-W2 Series Operating Instructions Manual page 17

3
Log on to Windows.
After confirming that the hard disk drive indicator (
and input the password, then select
computer will not operate.
4
Select your application.
You are able to start working on your computer.
NOTE
The power saving function is factory set, so if there is no input from a key, the touch
pad or an external mouse (when one is connected) for a certain interval of time, the
power to the LCD and hard disk may be turned off. The LCD will resume operation
when the touch pad or an external mouse (when one is connected) is used or a key is
pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode (
resume by sliding the power switch.
When switching to a different user with the Fast User Switching function, it may not
be possible to set the settings of the display. In this case, log off all users, and try the
operation once more. If the problem persists, restart the computer.
) has turned off, select the user
. Until the correct password is entered, the
"Standby/Hibernation Functions"). The computer will
17