Using Dgt Pi As A Regular Dgt3000 Clock; Software Update Or Re-Installation Of Dgt Pi Software; Copying A (New) Dgt Pi Software Image Onto The Sd Card (Windows) - DGT Pi User Manual

a6 StockFish 8
b6 Texel 1.07
c6 Arasan 2030
d6 Rodent 3229
e6 Zurichchess N
f6 Wildchess
g6 Galjoen 371
h6 Sayuri

Using DGT Pi as a regular DGT3000 clock

DGT Pi can also be used as a normal stand-alone DGT3000 chess clock. It is not necessary to
connect the power adapter when using DGT Pi as a chess clock. To save power we recommend
disconnecting the adapter. It is however necessary to insert the batteries.
You may use DGT Pi as a regular DGT3000 clock when you are playing a regular chess game or
when you play via a chess program on your computer. For more details please read the instructions
supplied with your e-Board. The clock cable that came with your e-Board is required if you wish to
use DGT Pi in combination with the regular DGT e-Board functions and without the DGT Pi
functions. Please note that when using the DGT Pi as a chess computer the clock cable should be
removed.

Software update or re-installation of DGT Pi software

DGT Pi comes with a pre-installed 8Mb SD card which is placed in a slot at the bottom. DGT Pi is
ready to play and normally it is not required to reprogram the installed software. If DGT Pi does not
function properly or a software update is available, reprogramming of the SD card may be required.
To update or re-install the software follow below instructions which require some minor computer
knowledge. If you are not comfortable to do this please ask someone to assist you. Feel free to
check the FAQ section on the DGT website or contact DGT support if you have any questions or
comments.

Copying a (new) DGT Pi software image onto the SD Card (Windows)

1. Shut down and disconnect DGT Pi from the power by unplugging the power cable.
2. Place DGT Pi upside down and press at 45 degrees a mini screwdriver into the SD card slot.
3. Gently slide the SD card out of the SD card holder. See following picture how to take out the
SD card (On the SD card there is small edge where you can place the screwdriver behind and
then slide the SD card out).
18