Check with your local service provider.
This equipment conforms to the recommendations on the exposure to radio waves when it is used in
its normal position next to the ear or at a minimal distance of 1.5cm. When a case, belt clip or holder
is used to carry the phone on the body, these should not contain metal and should position the
equipment slightly away from the body.
Sending data files or messages requires a good quality network connection. The sending of files or
messages can be delayed until such a connection becomes possible. Follow the instructions according
to the delay as the transmission hasn't been achieved.
II. Start to Use
1 Battery
The battery which is initially 50% charged can be used immediately. Please fully
charge/discharge the battery for the first three times to get maximum capacity.
1.1 Remove/Insert the Battery
Installing the battery
■
1. Take out the back cover of the smart phone;
2. Insert the battery to the correct battery pin and push it down to fix.
3. Cover the back cover.
■ Remove the battery
Remove the battery according to the remove guide or sticker.
Note:
(1) Remove the battery before shutdown.
(2) Be sure to operate in accordance with the above method steps.
1.2 Charge the Battery
During charging, the battery indicator on the Smart Phone is a thunder icon. If the device is
switched off during the charge, there will still be a charge indication on the screen that shows the
phone is still being charged. If the device is overused when the battery is low, it might take some
time to appear the charging icon.
When the battery indicator on the screen says 'fully charged', then thunder icon will disappear,
which means the completion of charging. If the tablet PC is switched off during charging, the screen
will have a 'fully charged' scene. It generally takes 4 hours to charge the battery. During charging, the
battery, the device and the charger will get hot. This is normal.
Attention: Charge the smart phone in a well ventilated place in which the temperature is from‐10
o
to +55
C. Use the charger provided by the manufacturer only. The use of unconfirmed charger may
lead to dangers and violate the manufacturer's warranty clause. If the temperature is too high or too
low during the charge, the device will automatically send a warning and stop charging to avoid
damage to the battery or any danger.
Operating environment
5
o
C
Need help?
Do you have a question about the RLTP5049C-BLACK and is the answer not in the manual?