Human Touch massage chairs HT-1650 Manual

Replacing the wood feet

Hide thumbs Also See for massage chairs HT-1650:

To ensure that Human Touch

products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all

product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

Tools Required: Phillips-head screwdriver, 6 mm Allen key, and two people.

NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

GET READY

1. Use the remote control to raise the backrest to the full upright position (Fig.1).

2. Power off the chair and unplug it.

3. Using two or more people, tip the chair gently over onto the side opposite the side

of the foot being replaced, so the foot being replaced is on top (Fig.2).

-1650

™

(Fig.1)

REPLACING THE WOOD FEET

06/01/08

SERVICE LEVEL: 1

(Fig.2)

Table of Contents

Do you have a question about the massage chairs HT-1650 and is the answer not in the manual?

Page 1 -1650 ™ To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all ® SERVICE LEVEL: 1 product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Page 2 6. Using two or more people, return the chair to its upright position. 7. Plug in the chair and power it on. (Fig.3) Rear foot Phillips screws Front foot Hex screws Please send any questions or comments regarding these instructions to: documentation@humantouch.com © 2008 Human Touch , LLC. ™...