Advertisement
Quick Links
AC 24OV, wyth AC adaptor (EP-15A)
Power source:
DC 9V (UM/SUM3 or R6 x 6)
[Australia only)
AC 11 OV - 127Vl22QV - 24OV,
Power source:
D C 9V (UM/SUM3 or R6 x 6)
8cm (3-l/8"), permanent dynamic
Speaker:
speaker
PMPO; 3.5W(AC operation)
Output power:
MPO; 2.6W(AC operation)
RMS; 1.5W (DC operation,
3 ICs, 1 transistor
Semiconductors:
4 diodes
Dimensions: Width;
Height;
Depth;
62mm (2-7/16")
1.1 kg (2.4 Ibs.) without batteries
Weight:
SPECIFICATIONS
10% distortion)
restored to its original condition and only parts
identical to those specified be used.
Compact cassette tape
Tape:
Frequency response:
38dB
Signal/noise ratio:
Earphone; 6 - 32 ohms
Output impedance:
AM; 526.5 - 1,606.5kHz
Frequency range:
FM; 87.6 - 108MHz
for this model are subject to change with-
Specifications
out prior notice.
T-15X
Advertisement
Related Manuals for Sharp QT-15XW
Summary of Contents for Sharp QT-15XW
- Page 1 T-15X restored to its original condition and only parts identical to those specified be used. SPECIFICATIONS Compact cassette tape Tape: AC 24OV, wyth AC adaptor (EP-15A) Power source: Frequency response: DC 9V (UM/SUM3 or R6 x 6) [Australia only) 38dB Signal/noise ratio: AC 11 OV - 127Vl22QV - 24OV, Power source:...
-
Page 2: Names Of Parts
NAMES OF PARTS 2. Stop/Eject Button . . : 3. Fast Forward Button 4. Rewind Button 5. Play Button 6. Record Button 7. Telescopic Rod Antenna Mode Selector Cassette Compartment 13. Carrying Belt 16. Battery Compartment DISASSEMBLY Prior to the disassembly, be sure to remove the AC adaptor, battery and cassette tape from the unit. -
Page 3: Mechanical Adjustment
MECHANICAL ADJUSTMENT F O R W A R D A N D Put a meter cassette in the cassette holder of the unit, torque and see that the measured torque in each mode is normal as shown in Table 3. 1. - Page 4 DIAL CORD STRINGING parts in the numerical order as shown in Figure 4-2. 2. Turn the tuning control shaft fully counterclockwise and fix its pointer to “0” point as shown in Figure 4-l. Tuning Control Shaft (128) GENERAL ADJUSTMENT INSTRUCTION Should it become necessary at any time to check the adjust- ment of this receiver, proceed follows;...
-
Page 5: Notes On Schematic Diagram
OSCILLOSCOPE CURVE FM SWEEP GENERATOR FM modulated. For adjustment in step 1, see [Note]. TEST REMARKS D STA- QUEN- ELECTRONIC High Adjust for Telescopic Earphone 10.7 VOLTMETER end of best “S” FM SIGNAL GENERATOR dial curve. RF (Connect instruments as shown in Figure 5-2.) 87 .I Band dial... - Page 8 (Nylon Bond...
- Page 10 “HOW TO ORDER REPLACEMENT PARTS” To have your order filled promptly and correctly, please furnish the following information. 1. MODEL NUMBER 2. REF. NO. 3. PART NO. 4. DESCRIPTION NOTE: Parts marked with “ A” are important for maintammg the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set.
- Page 11 DESCRIPTION CODE PART NO. DESCRIPTION CODE PART NO. Not Available Main Chassis Assembly Cl 24,125 Sub-chassis Head Base RESISTORS LRTN POO53AFZZ Retaining Ring, Fast Forward AA (Unless otherwise specified resistors are 1/4W, is%. Carbon type.) Gear 820 ohms, 1/8W, &5%, LX-BZ0451 AFFD Screw, Motor Retaining Carbon...
- Page 12 Guide, Pulley Frame (QT-15xw) Frame (QT-15XR) Frame (QT-15XB) (QT-1 SXW/XR/XB) Frame (QT-15X(BK)) Tuning Control Shaft Writer and Editor: Engineering Administration of Audio Systems Group, Sharp Corp. P r i n t e d i n J a p a n...