Before Starting; Changing A Setting - Whirlpool Estate DU3040XP Use & Care Manual

Option Selector Switch
Before starting your dishwasher
1. Spin the Upper Spray Arm to make
3. Run hot water at sink nearest
dish-
sure nothing will stop it from turning
washer until it is hot. Turn it off. (If yours
freely.
is a portable dishwasher, see page 14
2. Close and latch the door.
for connecting instructions.)
Starting your dishwasher
rinse
NORMAL HEAVY Cvcle...
Make sure Cycle control Knob points
to dot marked NORMAL HEAVY.
Select option.
Without turning it, pull the Cycle Con-
trol Knob out to start the Cycle.
NORMAL LIGHT Cycle...
RINSE & HOLD Cycle...
1. Turn Cycle Control Knob until it stops
1. Select AIR DRY Option only.
at dot marked NORMAL LIGHT.
2. Unlatch door and open slightly.
2. Select option.
3. Pull Cycle Control Knob out.
3. Without turning it, pull the Cycle Con- 4. Turn Control Knob clockwise to dot
trol Knob out to start the Cycle.
marked RINSE & HOLD.
5. Close and latch the door to start the
cycle.
Changing a setting
2. With the Cycle Control Knob pulled
out,
You can change a setting anYtime during
turn clockwise to the cycle you want.
any cycle.
3. Be sure the detergent dispensers are filled
1. Unlatch the doorto stop the cycle.
properly for the new cycle.
4. Latch the door to start the cycle.
B