1-4. Arranging Harness when Removing the HKC-WL50 (Outside Panel Assembly)
When replacing the HKC-WL50 (outside panel assembly) with another one, arrange the harness (DC-OUT-POWER) as described
below.
1.
Pass the harness (DC-OUT-POWER) through the clamper again.
2.
Place the harness (DC-OUT-POWER) at the back of the DPR-390 board.
Note
Arrange the harness (DC-OUT-POWER) avoiding area A to prevent the following.
Tip
This harness arranging is performed to prevent pinching of the following.
•
Pinching the harness when the outside panel is closed.
•
Pinching the harness when the HDLA is installed.
DPR-390 board
A
Clamper
Harness (DC-OUT-POWER)
23