Removing The Front Panel; Mounting To Rack (M5 Screw Holes); Mounting To Rack (Square Holes) - Sony PWS-110RX1 Installation Manual

1-6-2. Removing the Front Panel

Loosen the two anti-drop screws, and remove the front
panel.
Anti-drop screw
Front panel

1-6-3. Mounting to Rack (M5 Screw Holes)

Refer to the RMM-10 Installation Manual.
n
When fixing the rack angles of the unit to the rack, use the
screws (B5 x 12) supplied with the unit.
B5 12
1-8 (E)
Anti-drop screw
B5 12

1-6-4. Mounting to Rack (Square Holes)

Tighten the screws at the tightening torque below.
Tightening torque: 120 x 10
1. Attach the rack brackets in the side panels of the unit
with the specified six screws (B4 x 6).
Rack bracket
B4 6
2. Remove the release paper of the plate nut (M5) and
stick the plate nut to the front of the adaptor.
n
. Align the adaptor with the plate nut (M5) at the top
edges and at the lateral edges.
. Make sure that the centers of holes of the adaptor
and the plate nut (M5) are aligned.
(The following figure shows the left adaptor.)
Plate nut (M5)
Adaptor
Plate nut (M5)
_2
N.m {12.2 kgf.cm}
B4 6
Rack bracket
Release paper
Plate nut (M5)
Adaptor
Holes
PWS-110RX1