Bailey platinum standard PTSP Series Product Instruction page 8

SPECIFIC
WARNINGS
SPECIFIC
CAUTIONS
WBPEEUI110506A0
Consider the corrosive properties of the measured substance when
selecting piping materials. Degradation of the piping can upset the
process. Some process upsets can injure personnel and damage
equipment. (p. 3-4)
When pressurizing, avoid overloading and pressure hammer. Refer
to the introduction section for the pressure limits of the cell. Exceed-
ing this pressure could result in damage to the cell and cause seri-
ous injury to personnel. (p. 3-4)
Explosionproof/dust-ignitionproof installations and intrinsically safe
installations in Class II or Class III hazardous locations require that
the assembly be kept tight while circuits are live unless the location
is known to be nonhazardous at the time. (p. 4-1, 8-1)
The outputs of smart devices change to a fixed value during initial-
ization and detected failure conditions. These values must be
selected by the user to ensure safe operation. (p. 5-3)
System maintenance must be performed only by qualified personnel
and only after securing equipment controlled by the circuit. Altering
or removing components from an active circuit may upset the pro-
cess being controlled. (p. 8-1)
Do not remove the cell lock and rotate the electronics housing about
the cell. Doing so can damage the cell cable and will void the
warranty. (p. 3-3)
If the cell and characterization board assembly has been cleaned
for oxygen and chlorine service, do not compromise the integrity of
this cleaning during these procedures. Impurities will react with oxy-
gen and chlorine and damage the transmitter and the process.
(p. 7-3, 8-1)
Clean the diaphragms with a soft rag and appropriate solvent. The
use of metal brushes, blades, or other tools will damage the dia-
phragms. (p. 7-3)
Safety Summary
vii