Bailey platinum standard PTSP Series Product Instruction page 55

TROUBLESHOOTING
Message
Field device not
responding
Field device not sup-
ported by cartridge or
handheld
Field device output is
fixed or in adj. mode
Field device RAM failure
Input applied incorrectly,
calibration failure
Span & zero key misoper-
ation
Sorry, that routine not
implemented in ROM
D10
Unknown error
ERROR MESSAGES AND CORRECTIVE ACTION
6 - 4
Table 6-1. Error Messages
Fail
Probable Cause
Mode
No Type STT terminal not con-
nected properly.
Short in communication wire.
Transmitter does not have
minimum of 17 VDC across
inputs.
Not using correct communica-
tion method.
Transmitter or Type STT ter-
minal defective.
No Field device type not sup-
ported by release of Type STT
terminal firmware and
cartridge.
No Type STT terminal turned off
while 4 to 20-mA output was
being calibrated.
Transmitter cannot execute
command because of fix
output.
Yes Memory problem.
No Calibrated input outside fac-
tory allowable limits.
No Misoperation of EZ CAL
option.
Damaged EZ CAL option.
Damaged amplifier assembly. Replace amplifier assembly
No Cartridge not compatible.
No Transmitter reported an error
not understood by Type STT
terminal.
(continued)
Corrective Action
Check Type STT terminal wiring con-
nections. Refer to Figure
correct wiring arrangements.
Perform a continuity check to deter-
mine if a short exists.
Correct power problem.
Turn off Type STT terminal. Turn on
and select FSK/BUS and press ENTER
again. ID tags appear on screen.
Select ID tag of transmitter, or select
one appearing within brackets if unsure
of ID tag. Press ENTER. Press STA-
TUS key. If this error message is still
present, go to next step.
If available, verify that Type STT termi-
nal is functional by connecting to
another transmitter. Replace Type STT
terminal if not functional.
If Type STT terminal is functional,
replace amplifier assembly in transmit-
ter (Section 8).
Check to see if correct cartridge is
inserted into Type STT terminal.
Power down transmitter and power up
transmitter.
Take transmitter out of fix output. Refer
to Type STT Smart Transmitter Ter-
minal Instruction .
Replace amplifier assembly
(Section 8).
Correct signal and calibrate
(Section 8).
Try again.
Replace EZ CAL option (Section
(Section 8).
Purchase latest Type STT terminal
firmware. Refer to spare parts lists in
Type STT Smart Transmitter Termi-
nal Instruction .
Contact Bailey Technical Support.
2-4 or 2-5 for
8).
WBPEEUI110506A0