Page 2
INSTALLATION INSTRUCTIONS VOLT Spark Spotlight ® VAL-2007 Important: Please Read Before Installation This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
Page 3
Package Contents A. (1) Fixture Body Parts Required (sold separately) A. (1) MR8 Lamp Product Dimensions 1.4” 2.45” 3.4” 0.7” Install Stake Board Determine the desired location for mounting the stake. Hammer the stake into the ground until flange of stake is flush to grade. To avoid damage to the stake, place a board on top of the stake Stake...
Page 4
INSTALLATION INSTRUCTIONS VOLT Spark Spotlight ® VAL-2007 Install Fixture Body to Stake Pass the fixture wire through the center hole of the stake. Fixture Body Thread the fixture body onto Fixture Wire the stake and hand tighten until snug. Ground...
Page 5
Remove Glare Guard Rotate the glare guard counterclockwise to remove it Rotate from the fixture body. Glare Guard Fixture Body Install MR8 Bulb Insert the MR8 bulb with the correct wattage and type MR8 Bulb marked on the fixture label and push into place.
Page 6
INSTALLATION INSTRUCTIONS VOLT Spark Spotlight ® VAL-2007 Adjust Direction Loosen the knuckle at the joint to adjust the luminaire to your Rotate Luminaire desired direction. Always tighten the knuckle once your desired direction is achieved. Knuckle Install/Replace MR8 Bulb Please reverse Step 5 - Step 6 to expose the MR8 bulb and replace it with correct wattage and type marked on fixture label.
Need help?
Do you have a question about the Spark VAL-2007 and is the answer not in the manual?
Questions and answers