Table of Contents
Advertisement
Solving
Common
Dishwashing
Problems
A convenient
checklist for handling minor performance
problems. Go over this list before
calling for service. If you are unable to solve your dishwasher's
problem, turn to page 24 for
service information.
Solution
chart
PROBLEM
Food soil left
on dishes
CAUSE
Improper loading
Water temperature
too low
SOLUTION
Follow loading instructions
on pages 6-9.
Use the HIGH TEMP WASH option. If
needed, turn home water heater up to
ensure water entering dishwasher
is 120°F
(49°C) minimum. See "To check water temp-
erature" on page 19.
NOTE:
In some cases,
loads may not dry as well when using the
HIGH TEMP WASH option.
Use of incorrect, too
little, or ineffective
detergent
Detergent cakes in
dispenser
Use recommended
dishwasher
detergents
only. Follow recommendations
on page 10
for amounts. Never use less than one
tablespoon per load. Detergent must be
fresh to be effective. Always store detergent
tightly closed in a cool, dry place.
Use fresh detergent only. Do not allow
detergent to sit for several hours in a wet
dispenser. Check dispenser for caked
detergent. Clean dispenser when caked
detergent is present.
Insufficient fill due to
low water pressure
Home water pressure should be 20 to 120
pounds per square inch (psi) for proper
dishwasher fill. A booster pump on the water
supply may be necessary if pressure is
too low.
Spotting
and filming
Slowdown of wash
arm due to high suds
Hard water or high
mineral content in
water
Never use soap or laundry detergents.
Use
recommended
dishwasher
detergents only.
Use rinse agent to help prevent spotting
and filming. See page 11. To remove hard
water film, see "Removing spots and film" on
page 22.
Water temperature
too low
Use the HIGH TEMP WASH option. If
needed, turn home water heater up to
ensure water entering dishwasher
is 120°F
(49°C) minimum. See "To check water
temperature"
on page 19.
NOTE:
In some
cases, loads may not dry as well when using
the HIGH TEMP WASH option.
20
Advertisement
Table of Contents
