Network Setup; Connecting To Mp-40 With A Network Cable - Lyngdorf Audio MP-40 Owner's Manual

To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.

Network Setup

Connecting to MP-40 with a network cable

It is possible to get access to the MP-40´s web interface via a direct cable connection between the MP-40
and a computer, or a connection via a hub or switch.
If you have a direct cable connection to a laptop (with no switch or router between the two) the network cable
must be a crossover type. Furthermore, the Mode option in the Network Setup menu must be set to Manual
IP. Finally, you must manually set an IP address on the computer you intend to use for setting up the MP-40.
31