Micromario non-DI RU_EN
NanoCloud technology evenly distributes invisible water vapour into your room.
In dry conditions moisture from the humidi er will be absorbed by walls,
furniture, and other items in your room. Ventilation of dry outside air will also
increase the time it takes to reach the target humidity.
To optimize humidi cation and puri cation performance, it's recommended to
close doors and windows during use.
Hold for 3 seconds
Hold for 3 seconds: Display switch between
PM2.5 / IAI / Current humidity level
Allergen index from 1 to 12
where 1 indicates best air quality
3-digit display PM2.5 /
IAI / Humidity level
Poor Very poor
Rinse the water tank, the water tray and the
NanoCloud rotray humidi cation wick.
When display shows F0
Clean the pre- lter and wick
Descale the wick with the water and white
vinegar or citric acid, rinse with water and air dry.
When display shows A3 / C7 / F1
Time to replace NanoProtect lter
Time to replace wick
for 3 seconds to reset after
cleaning or replacing accessory
The lter may produce smell after being used
for a while because of the absorption of indoor
air. Remove the lter and place it where it has
direct sunlight and ventilation for several hours.
Re-install and try using it again. If the odor
Time to replace Active Carbon lter
remains, please replace the lter.
NanoProtect lter Series 3
4241 211 00181-1