Honeywell IDENT-KEY 3 Mounting And Connection Instructions page 36

36
Safety notes
Read the instructions carefully and thoroughly before installing the device and putting it into
operation. They contain important information on assembly, programming and operation.
The device is a state-of-the-art product. Only use the device:
- In accordance with regulations and
- When it is in a technically correct state
- In accordance with technical data.
The manufacturer is not responsible for damage that is caused by use not in accordance with regulations.
Installation, programming as well as maintenance and repair work may only be carried out by
authorized, skilled personnel.
Soldering and connection work should only be carried out inside the entire system when it is
deenergized. Soldering work should only be carried out using a temperature-controlled soldering bit
that is galvanically isolated from the power supply.
Observe the VDE safety instructions as well as the regulations of the local power supply company.
Do not use the device in a potentially explosive environment or in rooms with metal or
plastic decomposing vapours.
Mounting and Connection Instructions IK3 Evaluation Unit BUS-2