Samsung VR20T6001M Series Quick Manual page 3

• Mopping Robot may not be able to see objects that are below its sensors.
This may impact its ability to detect stair edges or other steep drops.
• Remove and allow mop pads to dry after use. Do not leave wet mops on floors for an
extended period of time, as you risk damaging your floors.
• Make sure that children or pets do not step or sit on the robot cleaner while operating.
• Mopping Robot is designed for indoor usage.
• Power off Mopping Robot whenever you are switching cleaning pads or adding
water to the mop kits.
• Make sure the sensor windows are clean and obstruction free prior to use.
• Make sure the water supply mop kit is filled with water and assembles to Mopping
Robot before use.
• Do not use Mopping Robot on black colored floors.
− Mopping Robot may not be able to operate normally.
• The cliff detection sensor may not detect a height difference less than 50 mm, and
therefore the product may fall. Be cautious when using the product.
Note
• Do not use the robot cleaner on a floor with a slope greater than 10°.
• Make sure the Mopping Robot battery is fully charged before each use.
• Remove obstacles (chair, etc.) for quick and thorough cleaning.
• After using the water supply mop kit and wet mop, clean them thoroughly.
• If Mopping Robot equipped wet mops are put on the floor plate for long time, the
mops may be contaminated.
• Remove the protective film from the product before use.
State of California Proposition 65 Warning (US only)
WARNING
This product contains chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
For battery recycling go to call2recycle.org
or call 1-800-822-8837
How to use Mopping Robot
VR6000TM_QG_Mopping-Robot_NA_EN.indd 3
3
2020-04-14 12:31:56