Briggs & Stratton 040375-02 Operator's Manual page 22

Wireless Monitor Operation
1. Remove battery access cover
monitor and install 2 AA batteries. (Observe correct
battery polarity which is embossed in the bottom of
the battery compartment). Replace battery access
cover.
generator ready
generator power
service needed
system update
DEALER NAME
DEALER PHONE
2. The wireless monitor does not have an on/off
switch. When batteries are installed correctly, the
GENERATOR READY green LED light will flash
once every 10 seconds indicating the status of the
generator.
NOTICE If communication does not begin upon placing
the generator in AUTO, installing batteries, and pressing
System Update, the monitor may need to be re-linked. To
link, follow Steps 3 through 6.
3. Locate the MENU AND ESCAPE buttons on the
B
control panel . Press and hold for 3 seconds to
enter the linking mode.
B
B
22
A
on back of
# of flashes service needed
1 low battery voltage 5 low frequency
2 low uid level 6 engine overspeed
3 under/over voltage 7 high temperature
4 engine does not start 8 transfer switch
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
A
MENU
OK
ESC
AUTO OFF
MANUAL
4. "LINKING MODE" will scroll across the generator
control panel.
5. Locate and hold the SYSTEM UPDATE button
on the wireless monitor for 5 seconds. All 3 LEDs
will flash until the monitor links to the generator.
Once it links, the monitor will display the current
state. The monitor will try to link for 1 minute. (This
step can only be completed when the generator is
in Linking Mode).
C
6. Once the link has been confirmed, press the OK
button on the generator control panel to exit or the
control board will turn off linking after 5 minutes. The
generator will now communicate with the wireless
monitor.
NOTICE It may take up to 1 minute for the monitor to
begin displaying the generator status correctly.
C
generator ready
generator power
service needed
system update
generator systems
DEALER NAME
DEALER PHONE