Inserting Of The Screws To Support The External Paneling - C.P.A. PISCINA MEDITERRANEA Installation Manual

MEDITERRANEA
16. Insert the screws to support the external paneling
In order to facilitate assembly operations, it is advisable at this stage to place the self-drilling M6
screws in the appropriate holes provided on the uprights and lower ribs, without tightening them
completely, but leaving a space of 2 mm between the hexagonal head of the screw and the element to
which they are screwed. This will greatly facilitate the assembly of the external paneling. This distance
must be tightened at the end of the installation of the external panels.
In the buttresses of the technical compartment the self-tapping screws must be installed externally, in the lower
pre-drilling and internally in the upper drilling as shown in the following image:
Once the correct coupling and alignment of the panels has been verified, the screws can be tightened
completely with the cordless screwdriver, checking that the heads of the lower screws adhere well to the
finishing panel.
WARNING
www.cpa-piscine.it
22 / 24
06/12/2019
Ver.00