Replacing Door Glass; Replacing The Door Seal; Replacement Spare Parts List - Nectre Fireplaces Big Bakers Oven Installation Instructions Manual

2.6.

REPLACING DOOR GLASS

This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
To replace the door glass:
1) Remove the four screws securing the glass retainers to
the door.
2) Remove the old glass.
3) Replace fiberglass rope seal if worn.
4) Fit the new glass into position
5) Screw down the glass retainers. Take extra care not to
over-tighten the screws as this could crack the glass.
6) Dispose of the old glass in a responsible manner.
Occasionally the M4 screws will have deteriorated from the
constant heat in the firebox, resulting in snapping off when
loosening. In this case, a new hole can be drilled in the door
and tapped using a 3.4mm drill bit and M4 tap.
2.7.

REPLACING THE DOOR SEAL

This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
1) Remove any remains of the old seal from the door.
2) Clean out the groove in the door that the seal was
bedded in, using a flat head screwdriver or equivalent.
3) Run a thin bead of the clear roof and gutter silicone along
the groove.
4) Starting at one end, press the new door seal into the
groove on the door.
5) Refit the door if it has been removed.
2.8.

REPLACEMENT SPARE PARTS LIST

Firebricks
4 Rectangular @ 230mm x 115mm x 38mm
2 Triangular @ 50mm x 70mm x 250mm
Brick Retainer
Stainless steel 495mm x 48mm x 25mm
Baffle Plate
Steel 248mm x 463mm x 6mm
Side Shields
Left and right pair @ 370mm x 255mm x 8mm
Door Seal
1610mm x 13mm round braided ceramic rope
Glass Seal
1360mm x 8mm x 3mm flat adhesive back
Door Glass
476mm x 200mm x 5mm pyro ceramic
6