Page 1
INELCO GRINDERS A/S AutoGrind USER MANUAL for Ultima-Tig for Ultima-Tig-Cut Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark E-mail: info@inelco-grinders.com , www.inelco-grinders.com...
Page 2
2006/95/EU and EMC-directive 2004/108/EU. AutoGrind is developed and produced according to following international norms: EN 61029 EN 61000-6-4 EN 61000-6-2 Responsible: Name: Anders Thy Date : 27.06.2018 Signature: _____________ Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark E-mail: info@inelco-grinders.com , www.inelco-grinders.com...
The control box shall be disposed as electronic equipment. The grinding module has to be dismantled, and the motor and cable shall be disposed as electronic equipment, and the rest as metal waste. Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark E-mail: info@inelco-grinders.com , www.inelco-grinders.com...
IEC plug is plugged in the control box and the female plug is connected to the male plug from the mains cable on the grinder Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark E-mail: info@inelco-grinders.com , www.inelco-grinders.com...
The AutoGrind module is then rotating faster for 15 sec. (the grinding time). The grinding time can be adjusted as necessary (see step #8) Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark E-mail: info@inelco-grinders.com , www.inelco-grinders.com...
AutoGrind is different than the standard electrode holder. Otherwise there is a risk that the cutting disc will cut through the electrode clamp and damage it. Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark E-mail: info@inelco-grinders.com , www.inelco-grinders.com...