Ricatech RMC160 User Manual page 7

Note : If in "REPEAT ALL" mode, the normal & program playing will also effect in this function.
RANDOM PLAY in CD
1. When playing the CD or MP3 disc,press the MODE button four times, the "RADDOM" indicator will light up.
+/-
2. Press the SKIP
3. To cancel random play, press the STOP button twice until the random indicator disappears.
PROGRAMMED DISC PLAY (CD)
It is not possible to enter programs during disc play. Press the Stop button (17) first, then follow
the instructions below.
1. Press the PROGRAM button(MODE)Button(12) on the unit . The following information will be displayed on
the CD Display.
2. Press the Forward and Reverse Skip Track buttons (14,15) on the unit to select the track to be stored in
location i.e. track 03).
3. Press the PROGRAM (mode) button. The first program selection is now stored in the program memory.
Listening to Programmed Tracks
Press the Play Pause button. Disc play will start at the beginning of the first programmed track .
To Clear The Program Memory
If the disc is playing, press the Stop button to stop the disc.
SOURCE SELECTING - STOP / CD / USB / SD (17) button
Press this button continuously 3 seconds, It will be switched to CD, or
USB or SD mode
USB- CARD OPERATION
1.Insert the USB or SD card.
2.Press FUNCTION button on the unit to select the CARD-USB mode,the unit will automatically
read the total folders and the number of the total tracks.
NOTE: only Mp3 file format is supported.
*Not all brand of USB flash disc is supported.
PlayingThe EntireCARD
1.Insert USB/SD CARD mode, the song will be autoplay. Playback starts with the first track,the
display shows the current track number.
2.To interrupt playback,press PLAY/PAUSE button.The time elapsed indicator will flash.
3.To resume playback,press the PLAY/PAUSE again.
4.To stop playback,press the STOP button.
ENCODING AND STORING FROM A NORMAL CD
You can encode you favorite CD songs into mp3 format and store them into your memory
device through the USB port or SD/MMC card slot.
1. Set the Function Selector (22) on the unit to choose the CD mode
2. Press the SKIP +/- button(14,15) to select the track ,then press the PLAY/PAUSE button (19)to be encoded.
3. Press the RECORD button(21) to start sync encoding and the display will show "USB or CARD" flash ing ,
4. Press the SKIP +/- button(14,15) to select recording into USB or Card drive, press the RECORD button to
confirm.
5. Press the Record button(21) or STOP/CD/USB/SD button(16) to stop encoding.
6. Remarks: Recording CD must be synchronized and press the STOP/CD/USB/SD button to confirm.
WARNING : Some originals CD's may not be recorded as they are protected against copying.
button , The tracks will be played randomly.
.
7