Advertisement
2
Installing the 10 Gallon Tank
No Parts Required
Procedure
1. Drill 4 holes (3/8 inch) in the existing fuel tank tray as
shown in
Figure
2.
1. 2.18 cm (0.86 inch)
2. Drill here.
2. Attach the new fuel-tank tray to the existing fuel-tank
tray and secure it with 4 flange-head bolts (5/16 inch)
and 4 flange nuts (5/16 inch) through the holes in the
tray
(Figure
3).
1. Flange nut (5/16 inch)
2. Flange-head bolt (5/16
inch)
3. Attach the carbon-canister bracket to the frame using 2
bolts (1/4 inch) and 2 flange nuts (1/4 inch) as shown
in
Figure
4.
Figure 2
3. 2.03 cm (0.80 inch)
4. 2.79 cm (1.10 inches)
Figure 3
3. New fuel-tank tray
Note: If the bracket does not perfectly line up with
the existing holes, widen them slightly using a 7 cm
(0.281 inch) drill bit.
1. Flange nut (1/4 inch)
2. Carbon-canister bracket
4. Secure the carbon canister to the carbon-canister
bracket using the canister strap and 2 carriage bolts and
flange nuts (3/8 inch) as shown in
1. Carbon-canister bracket
2. Flange nut (3/8 inch)
3. Carriage bolt
2
Figure 4
3. Bolt (1/4 inch)
Figure
5.
Figure 5
4. Canister strap
5. Carbon canister
Advertisement
