Maintenance Chart - AGT 5580/3 GX160 Owner's Manual

Please note that the following maintenance intervals apply for normal
operating conditions only. If your daily work requires longer than
normal or harsh cutting conditions are present the suggested intervals
should be shortened accordingly.
Complete Machine
Controls (Ignition
Choke Lever, Throttle lever)
Fuel Tank
Blade assembly
Gearbox oil
All Accessible Screws and
Nuts (not Adjusting Screws)
Air Filter
All Accessible Screws and
Nuts (Not Adjusting Screws)
Cylinder Fins
Starter System Vents
Starter Rope
Carburetor
Spark Plug
Engine Oil (1)
Valve clearance (2)
Combustion chamber (2)
Fuel tubes (2)
(1) After first month change Engine Oil.
(2) These items should be serviced by your servicing dealer, unless you have the proper tools and are
mechanically proficient.

MAINTENANCE CHART

Inspect (Leaks, Cracks, and Wear)
Switch,
Check Operation
Inspect (Leaks, Cracks, and Wear)
Inspect (Damage, and Wear)
Replace
Check level
Change
Inspect - Retighten
Clean
Replace (just for dual type)
Inspect
Retighten
Clean
Clean after finishing daily work
Inspect (Damage, and Wear)
Replace
Check Idle: (The blade assembly
must not rotate when the engine is
idling)
Check Electrode Gap
Replace
Check level
Change
Check - adjust
Clean
Check
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Every 300 hrs. (2)
X
X
Every 300 hrs.
Every 500 hrs.
Every 2 years
(Replace if necessary)
Every 100
Working h
Every 6
Months
Every Year
Every 6
Months
31