AGT 5580/3 GX160 Owner's Manual page 14

At first check all parts of the device and place them in front of you on the floor.
Assembling the front wheel (12) (Fig.3)
Attach the support wheel (12) to the frame as shown in figure 3. For this purpose, the two holes (3a +
3b) must be brought into conformity.
To lock the support wheel in the transport position (Fig.30+32):
1. Two holes (3a + 3b) must be brought into conformity,
2. Insert pin (3d) and securing it with cotter
3. Insert pin (3e) and securing it with locking screw (3f) and the cotter (Fig.3).
After installation, the wheel must look as shown in Fig.3.
To lock the support wheel in the working position (Fig.31+33+34):
1. Loosen the support wheel from the holes (3a) and relock it in the holes (3c).
After installation, the wheel must look as shown in Fig.33+34.
Fitting the Blades (Fig.3-5)
Tillage width 800 mm:
The tool holder (3g) has a hexagonal cross-section to
enable quick installation of the blades (14).
1. Grease the tool holder (3g) and observe the alignment of the mounting hole (3h) when installing the
blades (14) (Fig.3).
2. Insert the pin (B6, Fig.4) into the opening and secure it with the cotter.
3. Attach the blades (15) to the tiller and check the perfect alignment of the mounting hole (4a).
4. Insert the pin (B6, Fig.4) into the opening (4a) and secure it with the cotter.
5. Attach the end disc (16) to the milling broadening (15) and check the perfect alignment of the
mounting holes (5a).
6. Secure the end disc (16) with the fastening pin large (B6). Then secure the pin with the cotter
against loosening.
ATTENTION! If the pin is fitted incorrectly, it may become detached and impair operation of the
machine with resulting damage to the machine and operator safety risks!
ATTENTION – When fitting the blades ensure blades cutting edge is always facing into the
direction of travel.
The machine can be set to a narrower tillage width (50 cm):
1. Remove the fastening pin large (B6) and disassemble the milling protection disc (16) from the
milling broadening (15).
2. Remove the fastening pin large (B6) and disassemble the milling broadening (15) from the blades
(14).
3. Attach the milling protection disk (16) to the blades (14) and check the perfect alignment of the two
mounting holes.
4. Secure the milling protection disk (16) with the fastening pin large (B6). Then secure the pin with
the cotter against loosening.
Mounting Front Hand grip (H) (Fig.6)
Remove the hexagonal screws (6a) from the frame by turning counterclockwise.
Attach the front hand grip (H) with the previously disassembled hexagon head screws (6a) as
shown in figure 6.
14