Advertisement

Quick Links

SimpliFiber

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SimpliFiber and is the answer not in the manual?

Questions and answers

Summary of Contents for Fluke SimpliFiber

  • Page 1 SimpliFiber ™...
  • Page 2 IMPLI IBER 7IAH /KE@A...
  • Page 3 LIMITED WARRANTY AND LIMITATION OF LIABILITY...
  • Page 9 The Simple Fiber Solution...
  • Page 10 The S IMPLI IBER...
  • Page 11 The S Accessory Kits IMPLI IBER...
  • Page 12 λ...
  • Page 13 λ...
  • Page 16 Meter IMPLI IBER λ...
  • Page 19 Source IMPLI IBER λ...
  • Page 20 λ...
  • Page 21 LED Name Description LED Name Description...
  • Page 22 LED Name Description Calibration Technical Support Note All connectors and fiber end faces need to be clean prior to testing. Use the appropriate optical cleaning supplies to keep connectors and couplers free from contamination.
  • Page 23 Note Before calling Technical Support, please have your product version number available.
  • Page 24 Product Versions...
  • Page 25 The Reference Value...
  • Page 26 Note The launch cable used to set the reference value should be the same type as the cables to be tested: 50/125, 62.5/125, or single-mode The Reference Methods...
  • Page 27 Note When a connector is removed and then reattached, it is unlikely to go back into the exact same position. As a result, measurements will change slightly when connections are made or broken. SimpliFiber Meter SimpliFiber Source...
  • Page 28 Note When using a light source other than Source, press the to select the IMPLI IBER appropriate wavelength. Both units must be set to the same wavelength.
  • Page 29 SimpliFiber Meter SimpliFiber Source...
  • Page 30 SimpliFiber Meter SimpliFiber Source Note When using a light source other than Source, press the to select the IMPLI IBER appropriate wavelength. Both units must be set to the same wavelength.
  • Page 31 SimpliFiber Meter SimpliFiber Source...
  • Page 32 SimpliFiber Meter SimpliFiber Source...
  • Page 33 Note When using a light source other than Source, press the to select the IMPLI IBER appropriate wavelength. Both units must be set to the same wavelength.
  • Page 34 SimpliFiber Meter SimpliFiber Source...
  • Page 35 Saving Results...
  • Page 36 Viewing Results Deleting Results Note The most recent test will be deleted first.
  • Page 37 Uploading to a PC Scanlink...
  • Page 39 Measuring Power...
  • Page 40 Note When using a source other than S IMPLI IBER Source, press to select the wavelength.
  • Page 41 Meter IMPLI IBER...
  • Page 42 Source IMPLI IBER Physical Characteristics...
  • Page 44 - Store a new Reference value. - Remeasure...
  • Page 45 - Upload the stored test results to your PC. - Delete saved results from the unit’s memory. ’s memory is empty. IMPLI IBER - Change mode to CW prior to changing the wavelength - Send unit in for calibration - Verify connection between S and the IMPLI IBER...
  • Page 46 Verify connection between S and the IMPLI IBER PC and retry.

Table of Contents