Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
E73-TBX User Manual
2.2. Instructions for NRFGO STUDIO
One end of JLINK V9 is plugged into the USB port of the computer, and the other end is connected to the SWD burning
interface of the test board. After double-clicking the nRFgo Studio icon on the start menu or desktop, the following interface
appears:
Please notice the two circles in above picture. If the font in the first small circle shows black, which means JLINK V9
burner is detected by computer, and the driver is installed already. If it's grey, which means JLINK is failed to connected
to computer, then check below:
4) Whether JLINK V9 is on good condition
5)Whether USB cable is ok
6) The VCC and GND is on the correct connection in case of overcurrent
7) Whether the USB port of PC is loose
8) Whether it indicates abnormal information in the second circle in above picture as below:
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd.
15
Advertisement
Table of Contents
