Using Damp Dry; End-Of-Cycle Signal; Lint Signal - Whirlpool LG6881XS Use And Care Manual

Operating Instructions
Continued
- Using DAMP DRY
This setting should be used for damp
items that do not require an entire
drying cycle.
1. Set the Cycle Control Knob on
DAMP DRY in the TIMED DRYING
cycle.
2. Push the Start Button.
The dryer tumbles the load with heat
for 25 minutes, then without heat for
5 minutes.
End-of-cycle signal
'5
3 9- ' ,\-
The dryer sounds a signal to let you
know when the cycle is finished. The
signal cannot be turned off and is not
adjustable.
The signal is helpful when you are
drying permanent press, synthetic and
other items that should be taken out
as soon as the dryer stops.
Lint signal
Clean the lint screen before each
load. If you neglect to clean your lint
screen, the signal will sound. The
(whistle tone) signal lets you know the
air flow is being restricted. Restricted
air flow reduces drying efficiency.
Turn off the dryer and clean the lint
screen as shown on page 10.