Using Damp Dry; End-Of-Cycle Signal; Lintsignal - Whirlpool LE6098XFQ0 Use & Care Manual

Operating Instructions
Continued
Using DAMP DRY
Use this setting to dry damp items or to
leave wet items damp. (Heavy cottons,
for example, are easier to press when
damp and do not become stiff.)
1. Set the Cycle Control Knob on
DAMP DRY in the TIMED DRYING
cycle.
2. Push the Start Button.
The dryer tumbles the load with heat
for 25 minutes, then without heat for
5 minutes.
End-of-cycle signal
The dryer sounds a signal to let you
know when the cycle is finished. The
signal cannot be turned off and is not
adjustable.
The signal is helpful when you are
drying permanent press, synthetic and
other items that should be taken out
as soon as the dryer stops.
Lintsignal
Clean the lint screen before each
load. If you neglect to clean your lint
screen, the signal will sound. The
(whistle tone) signal lets you know the
air flow is being restricted. Restricted
air flow reduces drying efficiency.
Turn off the dryer and clean the lint
screen as shown on page 10.