DEC DECpc 433 Service Manual page 43

Troubleshooting
--------------
......
----------------·--------------·-------·---
Table 2-6. System Box Troubleshooting
(con,tinued)
Problem Possible Cause Action
l
Power is on, your Network failure Contact your system
Ethernet address is administrator or
installed on the server, network coordinator
but the system hangs
Network select switch Correctly set the
is m the wrong
network select switch
position
System does not boot Operating software is Install the operating
from the IDE hard disk not installed on the
system
drive
IDE hard disk drive
IDE hard disk is not Format the IDE hard
properly formatted or disk drive or correctly
the requested partition partition the IDE hard
I
does not exist disk drive using the
operating system
IDE hard disk drive
R1~fer
to the supplied
jumpers incorrectly sel
vendor documentation
IDE drive type
Run Setup to identify
incorrect
the correct drive type
Loose cables Chet·k all cable
connections
System does not boot Drive ID !ncorrectly set Make sure the drive ID
from the floppy disk
is set to 1
-
Floppy disk does not Insert tloppy disk with
contain start-uo files start-uo files
I
•
Floppy disk is worn or
Try
another floppy
damaged
disk
..
Loose cables
Check all cable
connections
DECpc 433 Workstation Service Guide
2-17